Out of Stock
PT100 temperature sensor - high temperature and precision
9.99€
Tax 8.26€
- Stock: Out of Stock
- Model: SensorTemp-PT100
Product out of stock
This product is out of stock, we will try to replenish it as soon as possible. You can request a notice by clicking on the green button (except discontinued products).
PT100 temperature sensor for high temperature and high accuracy, to be used in place of a thermistor or thermocouple. They are capable of measuring higher temperatures than thermistors (up to 300ºC), and are more accurate than thermistors and thermocouples in general.
Note that this is not a thermistor and unless your printer electronics support specific RTD sensing devices, you need an adapter.
Contains Dupont and XH connection pins.
PT100 | PT1000 | |
Precision | High | Medium |
Needs adapter board | Yes | No |
Susceptible to interference | Somewhat | No |
Temperature limit | Up to 430ºC depending on type | Up to 430ºC depending on type |
Special considerations | For best accuracy, use a 4-wire connection | Resolution less than PT100. No additional electronics required. However, to unlock your full resolution you need to change the 4.7k ohm resistor included on most boards to install the 1k resistor instead. In addition, the firmware configuration must be updated, depending on the installed sensor and resistance. |
100% Customers recommend this product
-
5 Awesome100%
-
4 Great0%
-
3 Average0%
-
2 Bad0%
-
1 Poor0%
Reviews Over PT100 temperature sensor - high temperature and precision
- (5)
Total Reviews (1)
click here write review to add review for this product.
Report this review.
Tags: temperature,
sensors,
spares,
for,
hotend,
trianglelab